FAQ - Frequently Asked Questions

How can I glue magnets? What do I need to know about self-adhesive magnets?

Table of Contents

How can I glue magnets?

Adhesive for magnets

If you would like to glue magnets, we can recommend the adhesive UHU MAX REPAIR for most applications. We offer it in our web shop.
As an alternative, refer to our selection of self-adhesive magnets and magnetic tapes (see below).

We cannot recommend hot glue since its high temperature may demagnetise neodymium magnets. Superglue is also not suitable since it may damage the coating of neodymium magnets.

What do I have to keep in mind with self-adhesive magnets and magnetic products?

Self-adhesive products at supermagnete.fr

Suitable base surface for self-adhesive products

Tips for all self-adhesive products

The adhesive on the backside of self-adhesive products requires certain surface qualities to be able to reach its full adhesive potential. Before a larger project we recommend tests since the surface condition has a big influence on the adhesive performance.
  • The surface needs to be free of dust, clean and dry. It is best to clean the surface prior to use with a suitable detergent and wait until it is fully dry.
  • The adhesive adheres only at full contact with the surface at full force: The smoother, the better the result. Avoid uneven or rough surfaces.
  • Remove the protective foil immediately before use.
  • In no case touch the adherend after removing the protective foil.
  • Certain synthetics, such as polypropylene (PP), polyethylene (PE) as well as powder-coated surfaces are not ideal since the adhesive may come undone under pressure. Hence, careful tests are essential before the actual use to avoid disappointments.

Tips for self-adhesive neodymium magnets

The following surfaces have proved to be especially suitable for self-adhesive neodymium magnets:
  • Uncoated cardboard (grey)
  • Coated cardboard (white)
  • Laser printing paper
  • Plexiglas (acrylic glass, PMMA)
  • Wood

Pressing and drying

After the placement of the products, the full length of the adhesive needs to be pressed onto the surface with a weight, so both surfaces can combine well. Thereafter, the adhesive needs to dry 72 hours to achieve its best adhesive performance. Only then can you put pressure or strain on the adhesive.
The ideal drying temperature is between 21 and 38°C. Temperatures above 80°C destroy the magnetisation of neodymium magnets and magnetic tapes.
The importance of correct pressing and drying time is illustrated in this example: The two tapes Magnetic adhesive tape ferrite 20 mm at the top of the picture were placed on a cleaned and transparent synthetic at room temperature, pressed and dried for 72 hours. Therefore, the tapes stuck evenly to the synthetic and could only be removed with considerable effort.
The two tapes at the bottom of the picture were pressed on the synthetic only for a short time. Already after 24 hours trapped air showed (light grey) and the adhesive force of the tapes was low. After another 24 hours one of the tapes detached from the synthetic all by itself.

Outdoor use

Even with correct application, air humidity and UV radiation can affect the adhesive of self-adhesive products over time.
  • Magnetic tape, magnetic sheet: Has only limited use outdoors and in wet surroundings such as bathroom or sauna, etc. because the adhesive gets damaged. If you still want to try it, you probably will need to replace the products from time to time.
  • Self-adhesive neodymium magnets are generally not suitable for outdoor use since they may rust.

Storage prior to use & shelf life

Store self-adhesive products at regular room temperature. Avoid too dry, too humid or sunny locations.
Please note the limited shelf life of the adhesive on