• Customer service in 3 languages
  • Over 46 million magnets in stock
The product was added to your shopping cart.
Go to shopping cart

Mendocino motor

Solar motor with levitating rotor
Author: Klingon77, Germany
Online since: 19/05/2010, Number of visits: 807407
2
Little by little I built a Mendocino motor. What makes it special is its (almost) levitating rotor, which is powered by small solar panels.
The rotor only touches a hard plate axially on one side and levitates otherwise, being carried by permanent magnets.

Manufacturing process for Mendocino motor

This is the base body of the rotor, which is made of 2 mm thick transparent polycarbonate.
My 3D CAD made it possible for me to design the pieces shapely and stable. My little CNC milling machine facilitated a speedy fabrication.
The first piece of the rotor is done. Later, the coil wire will be wound into the notches in the corners.
The solar panel is mono-crystalline and has a maximum current of approx. 200 mA at a voltage of approx. 0,5 V.
This translates into a maximum power of approx. 0,1 Watt.
The match shows the small dimensions of the motor.
I milled the pieces a certain way so I could insert the solar panel with little pressure and create a clamp-connection.
Later, the pieces will be glued together for a permanent hold.
Here you can see the finished glued rotor. The axle is made of acrylic glass since I couldn't find round polycarbonate rods.
I glued a steel sphere (1,2 mm diameter) into the tip (right).
It is hardened, offering durability with little wear and tear.
I put two R-10-04-05-N ring magnets on the front and the back of the rotor, respectively.
Then I built a mounting for the rotor, also made of polycarbonate. I put another four ring magnets into the depressions of the mounting. The rings in the rotor and the mounting reject each other and keep the rotor levitating.
I used a Q-40-20-05-N block magnet for a stator, which I embedded and glued into an acrylic glass plate.
In this picture, you can clearly see the dark wood inlaid (marquetry), which I added for aesthetic reasons.
I embedded a small wooden plate and a tiger's-eye on the side. This semi-precious stone constitutes the counter bearing to the steel sphere of the rotor. That's basically an inlaid work in the inlaid work.
The stone has a Mohs hardness of 6-7. So, it should last for a while when the rotor peak rests on it.
That's how it looks schematically
That's how it looks schematically
Here you can see the complete motor with all windings. Only now, when everything was done, did I glue the magnets to the mounting and the rotor.
The rotor actually levitates in the magnetic field! I am very happy with the result.

Mini Mendocino motor

Addition from Alain Gleyzes (2015): My goal was to build the world's smallest 3D-printed Mendocino motor. Instead of one large block magnet, I used four disc magnets and needed only two ring magnets due to the light weight.
You can find a detailed documentation of the assembly at Thingiverse.com.

Parts of the Mendocino motor

I used the following material:

The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.